antas-332 Modified Construction Silicone Sealant

Packaging : 600ml/sausage

Antas-332 is a one-component modified silicone sealant with room temperature curing and low modulus. It exhibits good adhesion and resistance to weather and stain. It can be brushed with paintings on the surface. Also, it’s environmental-friendly and has excellent adhesion to concrete, calcium carbonate board, fiber cement board, stone, ceramic and other porous materials. It is mainly used for waterproofing and joint sealing of wall panels on prefabricated buildings, also, could be used for joint sealing on other buildings.
Product feature
1. Excellent adhesion to most building materials, especially porous substrates.
2. Excellent performance of weather, aging and humidity resistance.
3. Excellent elasticity with movement capacity of 25% and tear resistance.
4. Good surface painting feasibility.
5. Good resistance to pollution and not easy to cause vertical flow pollution.
6. Low odor and environmental-friendly with low VOC and no isocyanate.
7. With wide range of temperature tolerance: from -40℃ to 90℃.
Main purpose
1.Joint sealing of concrete, GRC and other substrates on prefabricated buildings.
2.Joint sealing of road, bridge and runway.
3.Joint sealing of stone, ceramic board, etc.
4.Joint sealing of other building materials.
Standards compliant
GB/T 14683-I-F-25LM
Technical parameters
No. Test items Technique index Test result
1 Fluidity Sag/mm 3 0
2 Extrudability, ml/min 80 160
3 Elastic recovery, % 70 80
4 Tensile modulus, MPa 23 0.4 0.4
-20 0.6 0.6
5 Tensile adhesion 23 No destruction No destruction
90 No destruction No destruction
-30 No destruction No destruction
Water immersion No destruction No destruction
UV-radiation(300h) No destruction No destruction
6 Adhesion properties after hot pressing and cold drawing No destruction No destruction
7 Heat deterioration Mass loss, % 5 3
Crack No No
Powder No No
8 Anti-mildew level Level 0 or Level 1 Level 0
9 Pollution properties, mm Depth of pollution 2.0 0
Width of pollution 2.0 0
10 Shear strength at 23, MPa Report 0.4
Use restrictions
Antas-332 should not be applied:
1. On building materials that bleed oil, plasticized or solvent, to materials such as impregnated wood, oil-based caulks, green or partially vulcanized rubber gaskets, or tapes or bituminous below-grade waterproof and asphalt-impregnated fiber board.
2. In totally confined spaces.
3. When substrate surface temperature over45℃ or below 5℃.
4. On wet surface.
5. On the surface in direct contact with food.
6. For structural glazing.